You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Home Built Bale Processor
"Compared with the big round bale feeders we used before, we figure it easily saves us a half bale a day in wasted hay," says Harvey Lorton about the big bale processor/feeder he and his sons, Dan and Gary, built from scratch to feed round bales into fenceline feeders.
The key component in the bale processor is a
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Home Built Bale Processor HAY & FORAGE HARVESTING Bale Handling (5) 21-2-7 "Compared with the big round bale feeders we used before, we figure it easily saves us a half bale a day in wasted hay," says Harvey Lorton about the big bale processor/feeder he and his sons, Dan and Gary, built from scratch to feed round bales into fenceline feeders.
The key component in the bale processor is a 7 1/2-ft. section of a Brillion flail chopper. They also made use of the pto shaft, belts and pulleys off the chop-per.
The flail chopper mounts lengthwise on the right side of a 6 by 7 1/2-ft. hopper they built out of 12 ga. sheet metal. It's pto-powered by three V-belts and a 3-groove pulley.
Once the bale is loaded, a conveyor to the chopper chain, feeds the bale toward the rotor, peeling off a 2-in. layer of hay as the bale turns. The conveyor is powered by a low-speed, high-torque store-bought orbit motor that turns a 1 1/4-in. dia. shaft. The motor, which is detachable for other uses, is equipped with a small drive sprocket, while the conveyor drive shaft is equipped with a larger sprocket for a gear reduction of 4:1.
A custom-built concave, equipped with 3-in. sq. grates, grinds hay coming off the rotor into 3 to 4-in. lengths. An unloading auger off an old Gleaner combine mounts underneath the concave to feed hay onto the processor's belt conveyor.
The conveyor is 7-ft. long and 14-in. wide and is fitted with paddles. Height is adjustable with a winch and cable mounted on the side of the unit.
"To chop a bale properly, we have to run the tractor wide open and it doesn't take very long, either," says Lorton. "We can process half a bale at a time for loading into our 100-ft. fenceline bunk in less than five minutes."
The Lortons built their bale processor last fall for about $1,500. It handles big 5 1/ 2 by 6-ft. round bales.
Contact: FARM SHOW Followup, Harvey Lorton, Rt. 1, Box 134, Greenfield, Ill. 62044 (ph 217 368-2168).
To read the rest of this story, download this issue below or click
here to register with your account number.
