You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Super Bowl Bale Feeder
"We needed a hay feeder that could stand up to heavy abuse and that would reduce waste by encouraging cattle to keep their heads inside the feeder rather than pulling out to chew," says Pete Johnson, Ballantine, Mont., who built his own feeder 5 years ago.
The base of the feeder is made out of 6-in. dia. steel p
.......... You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Super bowl bale feeder LIVESTOCK Beef 12-4-10 "We needed a hay feeder that could stand up to heavy abuse and that would reduce waste by encouraging cattle to keep their heads inside the feeder rather than pulling out to chew," says Pete Johnson, Ballantine, Mont., who built his own feeder 5 years ago.
The base of the feeder is made out of 6-in. dia. steel pipe 15 ft. long with 45? angle elbows welded to the front end of each. both ends are capped with 5/16-in. thick steel plate. There are three 6-in. dia. cross pieces, 48 3/4 in. long - one is centered and the other two are 12 in. from each end. Four 4-in. dia. pipes, 46 in. long, were welded to each corner with 90? elbows, on top. Two 4-in. pipes run the full 15 ft. length of the top of the feeder. Two more 4-in. pipes run the length of the feeder about 41 in. above the 6-in. runners. There are nine 2-in. dia. uprights on each side on 17-in. centers and two uprights on each end on 24-in. centers. A 3 in. dia. pipe runs all around the inside of the feeder about 14 in. above the bottom runners. Tongue and groove flooring out of an old truck box attaches to the 3-in. pipe to close in the bottom of the feeder. Two 2 by 12-in. planks - nailed together at a 90? angle - make a "cone" down the center of the feeder.
"We've used this feeder for five years. It's needed no repair in that time and has practically eliminated waste," says Johnson.
Contact FARM SHOW Followup, Pete Johnson, Rt. 1, Ballantine, Mont. 59006 (ph 406 967-6204).
To read the rest of this story, download this issue below or click
here to register with your account number.