You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
ATV Tow Bar
I used square steel tubing to build my own 10-ft. long ATV spray boom. It covers three 38-in. rows at a time. The 3-section boom is supported by an angle iron frame that bolts onto the ATV rack. A pair of chains keep the boom ends from sagging. The boom folds up neatly for transport. The 14-gal. tank is equipped with a
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
ATV Tow Bar ATV'S ATV'S 21-1-36 I used square steel tubing to build my own 10-ft. long ATV spray boom. It covers three 38-in. rows at a time. The 3-section boom is supported by an angle iron frame that bolts onto the ATV rack. A pair of chains keep the boom ends from sagging. The boom folds up neatly for transport. The 14-gal. tank is equipped with a 12-volt pump.
Last spring I used the sprayer to apply Roundup in wet fields. I also used it in small corn to spot spray Banvel onto thistle patches. One problem is that there's no way to regulate sprayer pressure - I have to speed up or slow down to vary the application rate. I spent about $300 to build it which is more than I planned on. I spent about $70 for the nozzles and hoses alone. I probably didn't save more than $100 compared to a commercial sprayer of comparable size.
I also made my own ATV tow bar. The tongue is built from two sections of steel tub-the ATV. The pipe is connected to a steel plate that bolts onto the ATV's front guard. The tow bar folds up into three sections for transport. I spent about $75 to build it. (Richard Peden, 13109 N. 400 E., N. Manchester, Ind. 46962 ph 219 982-2218)
To read the rest of this story, download this issue below or click
here to register with your account number.
