You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Way To Keep Moldboards From Wearing
Jack Gardiner, Ilderton, Ontario: "The moldboards on my International 710 plow had holes worn through them near the center next to the shins. I found a way to keep the moldboards from wearing so that they last a lot longer - whenever I replace the points and shins I reuse the old shins. Since the old shins are shaped t
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Way To Keep Moldboards From Wearing FARM SHOP Handy Hints 21-1-31 Jack Gardiner, Ilderton, Ontario: "The moldboards on my International 710 plow had holes worn through them near the center next to the shins. I found a way to keep the moldboards from wearing so that they last a lot longer - whenever I replace the points and shins I reuse the old shins. Since the old shins are shaped the same as the moldboards everything looks custom made. I remove the bottom bolt from the moldboard near the shin. I use a longer bolt to fasten the old shin through the bottom hole onto the moldboard. Then I put a bead of weld on top of the old shin and mold-board. The old shin is sort of layered over the edge of the new shin (about 1/4 in.) and over the moldboard. This adds a lot of metal right where most of the wear occurs on my moldboard. Now my moldboards seem to last forever."
To read the rest of this story, download this issue below or click
here to register with your account number.
