You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Straight Through Hydraulic Press Straightenes 12 In. Wide Steel I-Beams
David Heinze, Belgrade, Minn., designed and built this 5-ft. 10-in. long "straight-through" hydraulic press to straighten out twisted 12-in. wide steel I-beams salvaged from old township bridges. He used the beams to build the steel frame on his 34-ft. wide, 72-ft. long machine shed.
The press is made from some
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Straight through hydraulic press straightenes 12 in wide steel I-beams FARM SHOP Tools 15-3-24 David Heinze, Belgrade, Minn., designed and built this 5-ft. 10-in. long "straight-through" hydraulic press to straighten out twisted 12-in. wide steel I-beams salvaged from old township bridges. He used the beams to build the steel frame on his 34-ft. wide, 72-ft. long machine shed.
The press is made from some of the same steel that it's designed to straighten. Four lengths of steel plate, 6 in. wide and 1/2-in. thick, are mounted on a pair of 42-in. long, 6 by 12-in. I-beams welded together with lengths of angle iron. An 8 by 12-in. H-beam on top of the press is 5/8-in. thick. The press table itself is 6 ft. 4 in. long and 20-in. wide. It's made from 3 by 12-in. channel iron, 3/8-in. thick, and can be raised or lowered by repositioning a 1 1/2-in. dia kingpin on each side. Heinze uses an IH 784 tractor to power the press's heavy-duty 5-in. hydraulic cylinder. The cylinder's 2 1/4-in. dia. shaft provides 25 tons of pressure at 2,500 psi.
"It's built so heavy that it straightens out a 30-ft. I-beam like it's playing with a toothpick," says Heinze. "When the press table is at its lowest position there's 3 ft. of vertical clearance between the table and the cylinder. I've used it to straighten out I-beams that had a 2 ft. bend. I block up the hydraulic cylinder and straighten the beams out 8 in. at a time. I built it because I couldn't find an affordable press built big enough to bend 12-in. I-beams. I tried driving my tractor over the beams to straighten them out, but itdidn't work. I've even used it to straighten out the 20-ft. long, 8 by 8 frame on a neighbor's 16-row Deere cultivator."
According to Heinze, the press isn't designed to press out wheel hubs be-cause it's so wide that it loses strength in the middle. "The real strength of my press is on the sides. If I could build it over I'd make it 1 ft. longer to get more leverage, and I'd install a 6-in. hydraulic cylinder for added down pressure."
Contact: FARM SHOW Followup, David Heinze, 41008 275th St., Belgrade, Minn 56119 (nh 619 254-R41R)
To read the rest of this story, download this issue below or click
here to register with your account number.
