You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Pull-Type Tile Plow Works Down To 50Ft Depth
After two wet falls in 1977 and 1978, Albin Murawski decided he had to find a way to tile his farm, which did not have a single foot of tile on it at the time.
A neighbor had built a 3-pt. mounted plow and he had read an article about a homemade pull-type tile plow in a drain-age contractors magazine. So he decid
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Pull-Type Tile Plow Works Down To 50Ft Depth TILING MACHINES Tiling Machines 19-5-10 After two wet falls in 1977 and 1978, Albin Murawski decided he had to find a way to tile his farm, which did not have a single foot of tile on it at the time.
A neighbor had built a 3-pt. mounted plow and he had read an article about a homemade pull-type tile plow in a drain-age contractors magazine. So he decided to build his own.
"It took three men three weeks to build this tiler in January of 1979," says Murawski, who already owned a dozer and backhoe when he built the tiler. "Since then, we've put in over 20 million feet of 4-in. tile at an average of about 36 in. deep. It will work down to a 5-ft. depth if we rip it once at a shallower depth before making a second pass to lay the tile. At times, we've hooked two 4-WD tractors on front of the dozer to pull it through a hill, so we know it's built tough."
The men bought most of the steel to build the plow at a scrap yard, but used a commercial digging point that's replace-able. The plow was built with three 8-in. I-beams, with one 12 ft. beam down the center and a 12-ft. beam angled off to either side. It's fitted with 52-in. wheels. A 2 3/4-in. dia. pin acts as a hinge point to lower the plow into the ground, and 1/ 2 in. steel plate was used for the sides of the plow itself.
The plow is 11 ft., 9 in. tall, formed out of 6-in. I-beams. Four 7-ft. long arms raise and lower it, holding it level when running through small hills or shallow troughs. A junked truck hoist provides lifting power on the hoist, and four press wheels from an IH planter guide plastic tile into the plow.
The unit was designed for 4-in. tile but Murawski has a boot he can use to install 6-in. tile also. A laser is used for automatic grade control.
"There are other tractor-pulled tile plows on the market now - both 3-pt. and pull-type - but we feel this is built as heavy and works as well as anything we've seen."
Contact: FARM SHOW Followup, Murawski Farms, 7276 N. Van Dyke Rd., Port Austin, Mich. 48467.
To read the rest of this story, download this issue below or click
here to register with your account number.
