You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Folding Stand Secures PTO Shaft For Transit
Brian Laine fabricated a folding stand to support the pto shaft on his manure spreader. The stand replaced a block of wood and a light rope Laine had previously used to hold the pto. The block and rope kept the shaft out of the dirt when not in use and let Laine move the spreader without connecting the pto first, but i
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Folding Stand Secures PTO Shaft For Transit POWER TAKE OFFS PTO S Brian Laine fabricated a folding stand to support the pto shaft on his manure spreader The stand replaced a block of wood and a light rope Laine had previously used to hold the pto The block and rope kept the shaft out of the dirt when not in use and let Laine move the spreader without connecting the pto first but it was a hassle “I was tired of tying down the pto shaft every time I moved it ” says Laine “The manufacturer didn’t build a shaft support so I did I just used metal stock I had lying around ” Laine designed the 2-piece support to rest on the spreader tongue when not needed The uprights of the top section are 12-in long 1 1/2-in by 1 1/2-in 3/8-in angle iron A top cross plate is a length of 8 7/8-in long 3/8-in steel With an arc cut out of the top for a shaft rest “I had a small piece of Lexan sitting around and decided to use it for the top clamp ” says Laine “I cut an arc out to match the remaining curve of the shaft ” To attach the top clamp to the steel plate he drilled holes through the width of the Lexan for two 10-24 by 1 1/2-in long stainless-steel screws with plastic knobs pressed on for ease of removal Where the screws met the steel plate he drilled and threaded receiving holes The upper section hinges on a bottom plate made from two short lengths of 2 by 3-in angle iron welded together in a U-shape Laine used self-locking nuts to bolt the two sections together leaving adequate play for the upper section to be raised into place and lowered but stay in place in either position “If I were doing it again I’d probably figure a way to accommodate different-sized shafts perhaps with a V-shaped resting spot and hold-down clamp instead of a circle ” says Laine “It’s a simple design and if anyone wants a CAD drawing with dimensions just send me an email ” Contact: FARM SHOW Followup Brian Laine 7921 Wade Rd Arlington Wash 98223 ph 425-879-2890; brianlaine@aol com; www lainefamily com
To read the rest of this story, download this issue below or click
here to register with your account number.
