Combine Front End Mounted On Farmall

Combine Front End Mounted On Farmall Larry Klahn turned a 915 IH combine steering system into a wide front end for his Farmall Super M TA SMTA The wide front made the SMTA a more useful loader tractor “The previous owner bought the SMTA new in 1954 and for the last 25 years used it to fill and pull a feed wagon ” says Klahn “However with its narrow front end when it was loaded it was really hard to steer ” Klahn runs a welding business in addition to farming and was tired of taking his loader off when using his loader tractor for farming The SMTA was going to be a dedicated loader tractor for use around the welding business and farm “I made a quick attach for the bucket and loader and built a set of pallet forks for moving pallets of seed or steel ” says Klahn “I decided I needed power steering and a wide front end ” Klahn looked for OEM and after-market wide front ends made for the SMTA by companies like Speeco and Schwartz Everything he found was very worn Power units made for the tractor by Behlen and Char Lynn were hard to find Klahn found a solution when a neighbor suggested he make a wide front with parts from a 915 combine “My neighbor had been parting out the 915 and the steering system was about all that was left ” says Klahn “I bought the steering axle steering motor steering wheel and all the hydraulics with it ” Klahn removed the narrow front-end pedestal and fabricated a mount for the combine axle that fit in its place He also removed the steering shaft and replaced the steering wheel on the throttle/steering wheel post with the steering wheel and motor from the 915 “I kept everything original in case I want to change it back at some point ” says Klahn “I can just unbolt the combine parts and bolt in the OEM parts ” Initially he tapped into the OEM hydraulics to power the steering However the SMTA had been underpowered hydraulically for the loader All it had was a small belt-powered pump off the engine It couldn’t handle both the loader and steering “I put a pto-powered hydraulic pump on the tractor and mounted a set of valves for it and auxiliary hydraulic needs ” says Klahn “The loader had been designed for one arm to be used as a hydraulic reservoir but it wasn’t needed with the OEM pump I cleaned it out filled it and tapped the pto pump into it I left the OEM pump to handle the steering ” Klahn made one more change to the SMTA “I took the original rear 13 6x38 tires rims and castings off the rear of the tractor and replaced them with larger castings with a double bevel 14-in rim and 15 5x38 tires ” says Klahn “Double bevel rims are more readily available and the larger tires handle heavier loads ” Contact: FARM SHOW Followup Larry Klahn P O Box 236 Hooper Neb 68031 ph 402-720-1032; redswelding@gmail com

To read the rest of this story, download this issue below or click here to register with your account number.