Old Sawmill Goes Mobile

Old Sawmill Goes Mobile WAGONS/TRAILERS Conversions When Travis Carpenter picked up a homemade sawmill he turned it over to the ranch manager and resident sawmill expert Mark Oconnell Oconnell is a former Vo-Ag instructor who at one time purchased his own small Hudson sawmill With it he could provide students with lumber they couldn’t afford to buy     “Mark is a phenomenal craftsman and keeps our place running with little downtime or incidents ” says Carpenter “All I did was purchase the sawmill It was his project and retrofit ”     Oconnell started with the sawmill It had about 18 ft of homemade track The mill didn’t run so his first task was to go through everything     “I put a new carburetor on it new bearings and new carrier bearings for the wheels to run on the tracks ” says Oconnell “I also put an electric winch on it to raise and lower the blade ”     Carpenter had picked up a self-loading bale carrier at auction a few years earlier When the sawmill arrived Oconnell could see the two were made for each other     “The carrier frame was perfect for the track ” he says     Most of the work he did on the carrier was stripping away the extras like the loading arm pivot point gears and chains plus all the hydraulics     “I thought I might be able to use the arm to pick up logs but it was too far forward ” says Oconnell     When the bale carrier had been stripped down to the frame Oconnell set the tracks for the sawmill carriage in place Although they were a hair wider than the bale carrier frame the track cross members sat on the 2 by 6-in carrier rails just fine Where needed he notched the carrier frame so the track sat flat When he put the sawmill carriage on the track he leveled the track so he wouldn’t have to shim logs when milling     “It was a perfect fit to marry the two together ” says Oconnell “The bale carrier frame is solid I’ve been around a lot of portable sawmills and this is as stable as it can get There’s virtually no setup when I pull it into the field to mill logs I put down the tongue jack unhook it from the tractor and go to work ”     Oconnell hung an old tank on the carriage for water to lubricate the blade “It seemed to fit ” he says “It has a nice brass valve to control water flow and a line to the saw blade ”     He also added about 7 ft to the track bringing it to about 25 ft total The length is also about right for his needs     “I can mill out a 23-ft footboard and then cut it up to hang between posts 10 ft apart ” says Oconnell      The actual throat is only 32 in but there is 50 in between the carriage uprights He is confident he could mill a log 4 ft in diameter flipping it over and raising and lowering the saw blade as he cut it down to a 4-sided cant     “I think I can mill just about any logs we might have here in Montana ” says Oconnell     Contact: FARM SHOW Followup Mark Oconnell 21 N Chestnut St Dillon Mont 59725 ph 406-925-2594; markoconnell1974@yahoo com

To read the rest of this story, download this issue below or click here to register with your account number.