You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Made-It-Myself No-Till Feed & Seed
Bill Hodgson gives his broadcast grass seed a boost by ripping slots in the ground with old plow coulters and dripping in liquid fertilizer. He mounted a small electric broadcast spreader to a pipe frame with a 3-pt. hitch and hooked a section of drag behind. It works great and about the only out-of-pocket cost was the
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Made-It-Myself No-Till Feed & Seed PLANTING EQUIPMENT No-Till & Min-Till Bill Hodgson gives his broadcast grass seed a boost by ripping slots in the ground with old plow coulters and dripping in liquid fertilizer He mounted a small electric broadcast spreader to a pipe frame with a 3-pt hitch and hooked a section of drag behind It works great and about the only out-of-pocket cost was the plastic fertilizer tanks He got the idea from fellow Ohio farmer Don Brown Vol 44 No 1 However Hodgson built his frame out of old pipe and other scrap he’d set aside “We use it in fields where the grass is wearing thin ” says Hodgson Hodgson used 2-in pipe for the 2 by 6-ft frame He used steam fittings for the right-angle elbows and welded in heavy-duty angle iron for cross members “I used 2 in pipe for an upright to mount the top link of the 3-pt and braced it to either side ” says Hodgson “I didn’t quite trust the butt weld on the upright so I ran two aircraft cables from the top link end to the rear frame and put turnbuckles on them for added support ” Hodgson is 86 and not anxious to wrestle the 3-pt hitch into place so he added standpipes two in front and one in the rear He sets them in place and lowers the seeder removing them when he hooks it back up He stores the front ones on the top of the frame “The standpipes make it easy to hook up the 3-pt ” says Hodgson “Everything is at the right height ” Hodgson varied his design from Brown’s by replacing the concrete block weights for down pressure with liquid fertilizer tanks If fertilizer isn’t needed he fills them with water Tubes with valves drip fertilizer into the slots made by the coulters “I’ve found I don’t often need to fill the tanks but if I need the fertilizer I can use them ” says Hodgson “I plan to add a pressure pump for better control Now I estimate how much to open the valves ” Contact: FARM SHOW Followup Bill Hodgson 4917 N State Route 60 NW McConnelsville Ohio 43756 ph 740-962-2489
To read the rest of this story, download this issue below or click
here to register with your account number.
