Powered Bale Unroller Built From Combine Drive Wheel

Powered Bale Unroller Built From Combine Drive Wheel BALE HANDLING Duane Marvin Preston Iowa went looking for a better way to unroll big round bales and ended up building a powered unroller using the drive wheel hub off an IH combine a used hydraulic motor and 2 bale spears made from semi truck and car axles He uses his Deere 6125 MFWD loader tractor to operate it “I use it every day on my 300-cow calf operation It’s a great way to limit feed cattle without wasting a lot of feed because all the animals get fed equally ” says Marvin “I spent less than $200 to build it not counting my time Everything I used to build it was bought used ” The bale spear is mounted on a rectangular frame made from 4-in square tubing with part of the combine’s drive axle and wheel hub welded to it The hydraulic motor is hooked up to the wheel hub and operates off tractor’s hydraulics He ground the semi axle down to a point to make a big spear then welded it to the center of the drive wheel He also made a smaller spear out of a car axle and mounted it off to one side He used 1/4-in thick steel to make a 4-wedge brace to hold the semi axle in place The big spear sets inside a short piece of pipe between the wedges The small spear mounted the same way A pair of parking stands off an old side delivery rake are welded to both sides of the rectangular frame to hold the unroller when it’s not in use Contact: FARM SHOW Followup Duane Marvin 5643 421st Ave Preston Iowa 52069 ph 563 543-6131; marvinfarm@gmail com

To read the rest of this story, download this issue below or click here to register with your account number.