You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Built-From-Scratch Truck-Mounted Workbench
Instead of bending over to work on equipment, 6-ft. 2-in. tall Konnor Bjelland built a big workbench on back of his service truck that stands more than 1 ft. taller than the small factory bumper it replaced. He built it by welding together 2 steel frames, one off a wrecked combine header, and the other off a wrecked gr
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Built-From-Scratch Truck-Mounted Workbench FARM SHOP Miscellaneous Instead of bending over to work on equipment 6-ft 2-in tall Konnor Bjelland built a big workbench on back of his service truck that stands more than 1 ft taller than the small factory bumper it replaced He built it by welding together 2 steel frames one off a wrecked combine header and the other off a wrecked grain drill “It’s mounted on my 2012 Ford F-350 Super Duty 1-ton service truck ” says Bjelland who farms and also works as a mechanic for a local Deere dealer “I looked at the workbenches on commercial service trucks and borrowed ideas as I went along ” One side of the truck is equipped with a big electric-hydraulic crane that reaches out up to 20 ft “I use the crane at work to do field service chores such as lifting final drive axles off sprayers and combines and on my farm to lift water tanks and air compressors The crane often would cause the truck to rock when lifting anything heavy so I added outrigger jack stands to both ends of the workbench to help keep the truck stable They fit into receiver hitches that I welded to both ends of the workbench ” An 8-in vise is bolted to the workbench and a small hinged door with a latch handle is built into both ends for storing tools The workbench is as wide as the truck and measures 14 in deep by 10 in tall Bjelland built it by cutting a 7 by 9-in chunk of square tubing off the header frame and a length of 6-in tubing off the drill frame and then welding them together The 7 by 9-in tubing forms the back side of the workbench and the 6-in tubing forms the front side A 3/8-in thick steel plate was welded on top of both frames To attach the workbench he welded short lengths of 3-in square tubing on front of the workbench and welded them to factory brackets on the truck’s body Contact: FARM SHOW Followup Konnor Bjelland 19517 Sollid Rd Conrad Mont 59425 ph 406 781-5011; Kbjel33@gmail com
To read the rest of this story, download this issue below or click
here to register with your account number.
