He Built His Own 3-Pt. Bale Mover

He Built His Own 3-Pt Bale Mover BALE HANDLING Cow-calf operator Kylidge McNally of Bethune Sask already had a loader-mounted grapple fork that could carry 2 round bales at a time out to his pasture However he wanted to carry an extra bale on back when feeding cows to cut down on the number of trips So he built his own 3-pt bale forks using part of the frame and forks off an old Brandt self-loading bale processor “It does a good job and cost very little to build ” says McNally “We’ve used the forks to haul more than 100 bales and find they really speed up our feeding time We usually haul 14 bales at a time to our cows which in the past required seven trips Now we need to make only five trips Also hauling a bale behind the tractor helps balance the load ” He flipped the bale processor’s frame 180 degrees and cut part of it off He had 3 used Brandt bale processor forks on hand 2 of which were bent He cut the bent portions off both and welded the two together end-to-end to make another fork Then he welded both forks to the frame and also added gussets as well as pinning brackets for the tractor’s 3-pt hitch You can check out videos of the home-built bale forks on McNally’s YouTube channel “KyFarmerman” Contact: FARM SHOW Followup Carr’s Repair 7641 Hwy 11 Barwick Ontario Canada ph 807 487-2548; www carrsrepairvintageparts com

To read the rest of this story, download this issue below or click here to register with your account number.