He Made His Own Custom-Built Vise

He Made His Own Custom-Built Vise FARM SHOP Miscellaneous As a metalcrafter and blacksmith who needs excellent tools in his shop Alexandre Bigunas was continually frustrated with his old bench vise that could no longer hold objects tightly Rather than buy a new one which might not be tough enough for his needs Bigunas decided to build his own His new vise has a 1/2-in thick carbon steel circular base that he cut out with his Sumig gas torch He honed the rough edges with his hand and bench grinders and bolted it to his metal workbench Bigunas made the slide from 1/2-in thick carbon steel tubing that glides back and forth through a channel opening that he made from 1/2-in steel plate welded to the top of the base He inserted thin metal wafers around the slide as he welded the channel together to avoid pinching Bigunas made the screw from a 3/4-in thick shaft and welded a 2-in anchor nut to the base at the opposite end of the slide He trimmed the radius edges of the nut flat on two sides so it could be welded securely in the U channel and still allow the slide and screw to glide freely Bigunas made jaws for both sides of the vise from 1/2-in thick by 2-in dia pipe tracing the angular outline with chalk before cutting with his Sumig torch Metal spacers and magnets held the jaws in place as he welded them with gusset supports to the main vise frame The anvil was made from solid XS300 metal and welded to the base of the stationary jaw providing more structural support for the vise He made the free-sliding handle from 1/2-in metal stock and welded bolts on both ends to keep it from sliding through the hole in the screw shaft He says his new vise is built stronger than anything he could’ve purchased Contact: FARM SHOW Followup Alexandre Bigunas www facebook com/alebigunas

To read the rest of this story, download this issue below or click here to register with your account number.