Tip To Avoid Grain Tank Gearbox Problem On Deere Combine

Tip To Avoid Grain Tank Gearbox Problem On Deere Combine COMBINES Miscellaneous Roger Gutschmidt Gackle N Dak : “The grain tank gearbox on my Deere combine which moves grain from the clean grain elevator chain to the bubble-up auger in the hopper failed a few years ago A new one cost more than $2 000 The housing is aluminum and the two bevel gears inside are made of steel The gears bearings and shafts inside run in 80/90 gear lube There is a seal on one end that is always in the grain If this seal fails dust gets inside the gear case and before long it is full of sludge and makes the bearings go out “When that happens the gears shift to the side and wear a groove in the aluminum housing and the belt that drives it comes off the pulley and you’re done combining for the day If you fix it yourself you’re looking at $2 500 in parts If a Deere technician fixes it it will cost $3 500 to $4 000 “My tip to avoid the problem is to lower the fold-down bubble auger and find the star-shaped drive wheel below it Take that off and then the oil seal is easily accessible Examine it for any kind of damage If it looks bad pry it out with a screwdriver and pound in a new seal Also check the oil in the case with the dip stick If it looks dirty at all dust is getting inside and that will tell you the seal is failing Replacing a $10 seal will save you a lot of money in down time and repair costs Also running the hopper to overflowing – or using a hopper topper – puts tremendous stress on this gearbox the clean grain elevator chain and the bearings not to mention the final drives transmission and tires It might look cool to have a heaping full hopper but you’re not doing your combine any favors ”

To read the rest of this story, download this issue below or click here to register with your account number.