Owners Report On Multiplaz Welder

Owners Report On Multiplaz Welder FARM SHOP Welders/Torches 64 After our recent reports on the first-of-its-kind Multiplaz welder which uses water and alcohol instead of gas a number of readers called to ask if “that new welder really works” So we chased down a few owners to see what they had to say The welder is not much bigger than a breadbox and runs on 110 or 220-volt power in addition to the water and alcohol To get more info on the welder itself call toll-free 855-314-5551 or go to www multiplaz com Dale Schoepflin Ellinwood Kan : “I’ve done just about every kind of welding in the past 45 years and I have to say the Multiplaz 3500 has worked very well for me It does everything the company says it will although the documentation was poor It does a beautiful job of welding A friend welded 2 pieces of 1/16-in steel with as nice a bead as you’d ever see Penetration was phenomenal I built a lawn cart just to get the hang of it and by the time I got done I was doing some real nice work I’ve deliberately made some bad welds and then was able to re-build them into real quality-looking beads It’s a lot like working with an oxy torch only it gets 3 times as hot I did a little stainless and was real impressed For portability you can’t beat it It doesn’t matter if you plug it into 110 volts or 220 volts I think 99 percent of the time you can use 110 and never trip a breaker After using this I’ll probably never use my acetylene again I think I can even use it to weld copper For people who are in remote areas if they’ve got a generator and a Multiplaz they can repair or build just about anything You can also bend metal Heat up 1/2 to 3/8-in thick steel and it’ll bend like butter Not a lot of heat invasion like you’d have with a torch ” Larry Land San Luis Obispo Calif : “The cost of the Multiplaz 3500 tool is a great selling point No other tool has the flexibility that the Multiplaz has and the cost of running it is almost zero compared to any other form of cutting or welding I think the way it cuts stainless steel is the most impressive thing it can do When we were cutting out circles and plate in stainless using the Multiplaz hole cutter it was amazing It cut right through with a pretty clean cut The amount of gear necessary to compete with the Multiplaz could easily go over $5 000 The fact that the machine can run on 110 volts or 220 volts and has a brain to switch over to the proper voltage that it’s plugged into makes it easy to use ”

To read the rest of this story, download this issue below or click here to register with your account number.