Toolbox Attached To Deere 318D Skid Loader Arms

Toolbox Attached To Deere 318D Skid Loader Arms FARM SHOP Miscellaneous Daniel and Frances Huppert River Falls Wis : Their Deere 318D skid loader has a small toolbox located under the seat in the cab However the toolbox is too small and hard to reach So Dan decided to attach a toolbox to the upper part of both loader arms “It puts my tools outside the skid loader where they’re easier to reach ” says Dan He bought two 15-in toolboxes as well as a 1/4-in thick rubber mat 2 snap pins and four 1/4 by 3/8-in hard steel bolts He welded 2 bolts to the upper part of each arm using the toolbox to measure where they should go He cut two 3 by 4-in rubber mats for each arm and bolted them on “The mat makes a good surface to set the toolboxes on ” says Dan He measured and drilled 1/4-in holes in the toolboxes to match the bolts then set the toolboxes over the bolts and onto the mats Next he cut two 6 by 15-in mats and set one mat inside each toolbox The mats keep the tools from sliding around He also attached a snap pin to each toolbox latch to keep the toolboxes from accidentally opening up while operating the skid loader

To read the rest of this story, download this issue below or click here to register with your account number.