Electric Drill Powers Pickup Dump Box

Electric Drill Powers Pickup Dump Box FARM SHOP Tools When Craig Spierling wants to raise his truck’s dump box he pushes a button in the cab that turns on an electric drill which direct-drives the hydraulic pump Retrofitting a hydraulic pump from driveshaft to drill-driven was easy It also cost less than alternative drives just as the dump beds did
    “I had picked up a couple of old dump trucks left in fence rows ” says Spierling “Their hydraulics are self contained The pump attaches directly to the cylinder which is actually inside the reservoir ”
    Spierling mounted a 1 1/2-yard box on a 1980 Chevy pickup Originally the pump was driven off a jackshaft from the transmission The multi-piece 3/4-in jackshaft angled up to the pump Modifying it to run off a drill powered by a 3 500-watt power inverter was a lot easier than rigging up a new driveshaft He also beefed up the power system on the truck with a heavier duty battery under the hood
    “The inverter is also handy for powering tools and even a grain elevator That takes a lot of amps especially if the elevator is full I figured if it could handle the elevator it could handle an electric drill driving the pump ”
    He took a piece of jackshaft and turned down one end to fit a 1/2-in drill He kept the keyway on the other end to match the pump
    “I welded a bracket to the pump mount and built a steel box for it that would hold the drill ” says Spierling
    He removed the handle from the drill and used the handle mount to secure the drill in the box He put a Lovejoy coupler on the end of the pump and attached the modified jackshaft to it and the drill which he locked in the on-position He ran a rod from the lift lever on the pump to a T-bar switch mounted through the floorboards and next to the master switch for the inverter
    With the inverter on power for the drill travels from the inverter via extension cord to a push-button switch on the dash To start the drill he hits the button To activate the lift Spierling turns the T-bar
    It’s a simple system and one that he recommends to others He did all the work in his garage with common tools including replacing the dump box with a stake bed
    “You see those old trucks around and they often haven’t been used in decades ” he says “I paid $50 for one truck and $100 for another The pumps worked fine and I only had to add some packing to stop a leak in one cylinder ”
    Contact: FARM SHOW Followup Craig Spierling 1627 Cassidy Rd Levering Mich 49755 ph 231 537-2324

To read the rest of this story, download this issue below or click here to register with your account number.