Tractor Built From Case Combine

Tractor Built From Case Combine COMBINES Conversions When Kevin Ford needed a snowblower tractor that could blow snow into trucks he started thinking about building it himself When he saw the tractor his friend Herb Hallman built out of a combine he knew it would work     “Big cities have them but our town couldn’t afford a commercial rig ” says Ford who is a city maintenance worker for his small town “Using a front-end loader is slow and dangerous around car traffic ”     Ford decided to go with a Case IH 915 combine for its heavier final drives heavier transmission and turbocharged engine He figured the 135 hp would be needed for the 11-ft snowblower he planned to use     After stripping down the combine Ford began repositioning the components he needed on an old truck frame cut down to 14 ft He reinforced the cross members and rebuilt all the clutches with new bearings     Ford narrowed the combine drive axle by a foot before mounting it along with the steering axle engine and transmission to the frame He also mounted the original cab fuel tank and hydraulics     In preparation for mounting the snowblower Ford welded a 1-in thick plate to the front end of the frame just ahead of the drive axle To adapt the combine motor to drive the snowblower he used a pto case off a Case 2670 tractor After drilling a hole through the plate for the driveshaft Ford mounted the pto case to the blower side of the steel plate     He fabricated a 3-pt hitch on back of the steel plate using tabs with 1-in holes welded to the plate on either side of the pto case For lift he mounted the combine header lift cylinders to the outside of the truck frame which push on the lower arms of a rocker shaft mounted to the top of the steel plate As the shaft turns it provides lift for the 3-pt arms mounted to the tabs     In order to use the separator clutch on the combine to engage and disengage the pto Ford took the drive pulley from the separator drive to a machine shop     “They salvaged the splines and mated them to the U-joint on the end of the 2670 driveshaft ” says Ford “This meant I could use the separator clutch lever in the cab to engage the snowblower with direct engine power ”     When Ford ran into problems with insufficient hydraulic pressure for the hydrostatic transmission a mechanic suggested separating hydraulics from hydrostatics He now uses the hydrostatic system with its own pump and reservoir for drive A second pump and reservoir service other hydraulic needs such as the discharge chute 3-pt lift steering etc He also installed electric-over-hydraulic switches on all the valves for easier control while driving     Ford found a used 1100 Schulte snowblower He put all new sprockets and bearings on and relined the impeller At 110 in it clears a path well past the 9-ft tractor wheel width     “I can load about 12 yards of heavy wet snow in about a minute and 12 seconds ” says Ford “The blower beats the air out of the snow too so every load is about 50 percent heavier It is faster than a front-end loader It is a poor man’s fix for a small town that couldn’t afford a new rig ”     Ford estimates he paid $2 800 for the combine but the town has since reimbursed him for all his costs “When I told my boss what I wanted to do he thought I was crazy ” recalls Ford “When I showed him my friend’s tractor he understood and said that if it worked the town would reimburse me It’s now in its sixth season and has been trouble free I put on 100 to 150 hrs every season ”     Contact: FARM SHOW Followup Kevin Ford P O Box 218 Kelvington Sask Canada S0A 1W0 ph 306 327-4764; klfordx2@gmail com

To read the rest of this story, download this issue below or click here to register with your account number.