You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Snowblower Gets New Life With Snow Blade
“I built it about a year ago and can’t imagine how I would get along without it,” says Don Campbell, Gaylord, Mich., about the snowblower he fitted with a 51-in. wide snow blade. “The blower had been sitting around unused for several years, and the auger was rusted solid. Instead of spending several hundred dollars on
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Snowblower Gets New Life With Snow Blade MISCELLANEOUS EQUIPMENT Miscellaneous “I built it about a year ago and can’t imagine how I would get along without it ” says Don Campbell Gaylord Mich about the snowblower he fitted with a 51-in wide snow blade “The blower had been sitting around unused for several years and the auger was rusted solid Instead of spending several hundred dollars on new parts I used a torch to cut off the blower and replaced it with the blade ” The 2000 Deere snowblower is powered by an 8 hp Tecumseh engine with only 10 hrs on it He cut off the auger and impeller then made a circular cut all the way around the back side of the housing where the impeller had been He used 16-ga sheet metal to weld together a new box frame fitted with 2 blade pivot points One pivot point is welded on the front of the snowblower and the other on the back of the blade The blade pivots on a pair of 1/2-in dia pins one at the top and one at the bottom “By pulling out another center-mounted pin with a steel ring on top I can rotate the blade left right or straight ahead ” says Campbell He used 16-ga sheet metal to build the blade and reinforced it by welding a length of 2-in flat bar on back He also welded on a cutting edge made from 2-in wide by 1/4-in thick flat metal He replaced the snowblower’s original 8-in wheels with 12-in wide by 18-in tall wheels off a Steiner lawn tractor using 1/4-in plate steel to build wheel adapters “I had a couple of 4-bolt tires and wheel rims sitting in the shop that bolted right up after I put some spacers in between to clear the frame ” says Campbell “I’m real happy with how this little walk-behind plow turned out It takes up very little space in my garage ” he says “I used it a lot last winter to move snow away from the edges of our driveway and sidewalks If we get less than 5 in of snow I just do the entire driveway with it It’ll push right through 6 in of light snow ” Contact: FARM SHOW Followup Don Campbell P O Box 132 433 N Ohio Ave Gaylord Mich 49734 ph 989 732-3946; doncampbellmodels@yahoo com
To read the rest of this story, download this issue below or click
here to register with your account number.
