You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Weed Eater Outboard Motor
"It works as good as an electric trolling motor and didn't cost much to put together," says Terrell Webster, McAllen, Texas, who used parts from several old weed trimmers to make an outboard motor that he mounts on his 12-ft. "john" boat.
Webster used the straight shaft off a McCulloch weed trimmer and mounted t
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Weed Eater Outboard Motor CROPS Weed Control 18-1-6 "It works as good as an electric trolling motor and didn't cost much to put together," says Terrell Webster, McAllen, Texas, who used parts from several old weed trimmers to make an outboard motor that he mounts on his 12-ft. "john" boat.
Webster used the straight shaft off a McCulloch weed trimmer and mounted the power head off a Ryan weed trimmer at one end and a Ryan cutterhead at the other. Then he attached a Minn-Kota propeller (designed for an electric trolling motor) to the cutterhead. He uses a C-clamp, that's bolted to the shaft with a pivoting bracket, to mount the motor on the boat. The makeshift outboard pivots up and down on the mounting bracket like an oar in an oarlock.
"The only part I bought was the propeller for $20. I removed the string head from the Ryan cutter head and replaced it with the propeller by drilling out the propeller hub. I used a straight shaft instead of a curved shaft so the propeller would run straight. I control my speed by raising or lowering the propeller."
Contact FARM SHOW Followup,
Terrell Webster, 6104 N. 31st Si, McAllen, Texas 78504 (ph 210 687-4061).
To read the rest of this story, download this issue below or click
here to register with your account number.
