You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Homemade Socket Holder
Chuck Knipp, Palco, Kan.: "I have a lot of sockets in my shop without cases and nowhere to put them. So I made a socket holder using a piece of 1 1/2-in. angle iron mounted to the wall. I spaced the sockets out on the bar and then marked each location with chalk. Then I ground down the points on some nails and tack-
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Homemade Socket Holder FARM SHOP Miscellaneous Chuck Knipp Palco Kan : I have a lot of sockets in my shop without cases and nowhere to put them So I made a socket holder using a piece of 1 1/2-in angle iron mounted to the wall I spaced the sockets out on the bar and then marked each location with chalk Then I ground down the points on some nails and tack-welded them to the bar After a little paint I had a cheap durable socket holder I made a rotating screw and nail holder by welding a piece of 3/4-in sucker rod to an old disc blade to make a stand Then I attached metal grain leg buckets to pieces of strap iron that fit over the sucker rod Four buckets weld to each strap iron bracket which has a 3/4 in hole in it I tack-welded large washers to the sucker rod to hold each set of buckets in place They spin freely around the rod It took only a couple hours to build but is a great way to organize screws nuts bolts nails staples and other small parts
To read the rest of this story, download this issue below or click
here to register with your account number.
