You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Old Combines Converted Into Cheap Sprayer Caddies
"These homebuilt tricycle sprayer caddies incorporate herbicides accurately and cost very little to build," says Roger Schuelke, Marietta, Minn., about the rigs he and his brother Andrew built last winter, borrowing the tires and drivelines off two old Case 960 combines.
Roger's 4-wheel caddy, with two rear 18.4
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Old Combines Converted into Cheap Sprayer Caddies COMBINES Conversions 12-3-36 "These homebuilt tricycle sprayer caddies incorporate herbicides accurately and cost very little to build," says Roger Schuelke, Marietta, Minn., about the rigs he and his brother Andrew built last winter, borrowing the tires and drivelines off two old Case 960 combines.
Roger's 4-wheel caddy, with two rear 18.4 x 26 combine tires and two front 10.00 x 20 front tires, holds a 750 gal. poly tank. He pulls the caddy behind a Versatile 800 4-WD tractor and 43 ft. field cultivator.
Andrew's 3-wheel caddy, with three 18.4 x 26 combine tires, holds a 500 gal. poly tank. He pulls the caddy behind a Ford TRS 35 tractor and a 30 ft. field cultivator.
On both caddies, the combine's original 3-speed transmission drives a sprayer pump, sending chemicals to booms on the cultivators. To put the transmissions in gear, the brothers simply flip a lever, enabling the transmission to turn the shaft that normally would turn the combine's clutch. Roger runs the transmission in second gear to power a centrifugal pump; Andrew runs in third gear, to power a roller pump.
Roger, who used the sprayer caddy last spring on 420 acres of soybeans, says he built the rig for about $1,000. "I paid one neighbor $100 for the driveline, and another neighbor several hundred dollars for combine tires. The rest went for building the frame."
According to Roger, the homemade sprayer caddy works better than commercial equipment with ground driven positive displacement pumps. "Those pumps are accurate, but expensive. The pump alone costs about $1,200, which is more than it cost me to build my whole caddy. What's more, commercial caddies with ground driven pumps aren't equipped with an agitation system. Mine is. I can keep chemicals suspended while I'm traveling, and if the tank sets for a while I simply pull the caddy down the field to agitate it," Roger points out.
The driveline, 10 ft. long and 4 ft. wide, consists of the transmission, bell housing, and planetary gears. To hold the driveline, Roger built a frame from 6 in. channel iron, adding a floor made of 2 x 10 boards. Then, he installed the 750 gal. poly tank, using cable to strap it to the frame.
He then built a short gooseneck which extends 18 in. ahead of the flatbed and is attached to a pivot point between the two 10.00 x 20 truck tires. Roger made the pivot point by welding the tires' spindles back to back, hubs facing outside. He welded the spindles on the bottom of a 4 in. (outside dia.) pipe and slipped a piece of 4 in. (inside dia.) pipe over it.
The tires on both caddies are on 120 in. centers and can straddle 30 in. rows perfectly, says Roger. "Andrew's home-built caddy, with a single front wheel, could even be pulled behind a mounted planter to apply liquid starter fertilizer." For more information, contact: FARM SHOW Followup, Roger Schuelke, Box 124, Marietta, Minn. 56257 (ph 612 668-2532).
To read the rest of this story, download this issue below or click
here to register with your account number.
