You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
How To Make A Rip And Cross Cut Guide For Panels
Arco Rosenow, Chillicothe, Ill.: "To make a rip and cross cut guide for panels, start with a piece of 1/4-in. thick plywood that's 8 ft. long by 12 in. wide. Set your power saw on the plywood like you're going to rip it, with the blade just touching the wood. Then measure over 1/4 in. away from the edge at both ends of
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
How To Make A Rip And Cross Cut Guide For Panels FARM SHOP Handy Hints 30-2-36 Arco Rosenow, Chillicothe, Ill.: "To make a rip and cross cut guide for panels, start with a piece of 1/4-in. thick plywood that's 8 ft. long by 12 in. wide. Set your power saw on the plywood like you're going to rip it, with the blade just touching the wood. Then measure over 1/4 in. away from the edge at both ends of the 8-ft. length, and snap a line from end to end. Screw a 1 by 2 to the plywood along the line, then place the edge of the saw's shoe plate against the 1 by 2 and rip off the 1/4-in. excess. What you now have is an accurate rip and cross cut guide. Just position it on the mark to cut, clamp the guide to the panel you want to cut, and you'll be able to make a cabinet grade cut."
To read the rest of this story, download this issue below or click
here to register with your account number.
