Shaft Built Back Up With JB Weld

Shaft Built Back Up With JB Weld FARM SHOP Repairs 26-2-39 E. Yastrubecki, Paynton, Sask.: "The bottom rear roller bearings starting turning on the shaft on my Hesston 5500 baler. Rather than replace the entire roller, which would have been expensive, I built the shaft back up with JB Weld. It worked 100 percent. I haven't had any problems in the two years since I made the repair. Best of all, it cost almost nothing. JB Weld is very versatile and long lasting. I've found lots of uses for it. It's hard to believe it works as well as it does."

To read the rest of this story, download this issue below or click here to register with your account number.