Pickup Transmission Powers Nut And Bold Rethreader

Pickup Transmission Powers Nut And Bold Rethreader FARM SHOP Miscellaneous 25-3-38 Putting new threads on old nuts and bolts by hand can be a slow, tiresome job. To make the job easier, Stan Knafelc, Watson, Sask., uses an old 3-speed pickup transmission that's belt-driven by a 1/4 hp electric motor. The entire setup bolts to the top of a welding table in Knafelc's shop. He attached a big pulley to the transmission's clutch shaft and fitted an adjustable chuck to the output shaft, which holds taps and dies for cutting threads. He puts the transmission in gear, then uses a pliers to force a nut over the thread cutter. To withdraw the nut he simply puts the transmission in reverse. "It's fast and a lot easier than rethreading nuts and bolts by hand. It doesn't take long to rethread a whole bunch of nuts or bolts," says Knafelc. "I can rethread nuts ranging from 1/4 to 3/4 in. diameter. The big pulley gears the transmission way down so that it runs slow. I keep the transmission in second gear so the thread cutter rotates at about 60 revolutions per minute. I used a synchromesh transmission so that I can shift the thread cutter into reverse without having to stop the motor." Contact: FARM SHOW Followup, Stan Knafelc, Box 67, Watson, Sask., Canada S0K 4V0 (ph 306 287-3789).

To read the rest of this story, download this issue below or click here to register with your account number.