You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Another Motorized Pedal Tractor
"I've often wanted to comment or send you photos of some of my projects but it wasn't until after reading the last issue that I finally decided to write," says Frank L. Miller, Mott, N.Dak.
"The motorized pedal tractor that you showed wasn't bad but it was big and I didn't think it still looked like a pedal trac
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Another Motorized Pedal Tractor FARM HOME Miscellaneous 24-6-24 "I've often wanted to comment or send you photos of some of my projects but it wasn't until after reading the last issue that I finally decided to write," says Frank L. Miller, Mott, N.Dak.
"The motorized pedal tractor that you showed wasn't bad but it was big and I didn't think it still looked like a pedal tractor after the motor was installed. I thought your readers would like to see a motorized tractor I put together for my grand kids. They must have put a million miles on since I built it 10 years ago.
"The tractor is built out of a Deere 20 series pedal tractor which I completely restored. I cut the center part out of the hood and installed a 3 1/2 hp Briggs & Stratton gas engine. The engine direct-drives a centrifugal clutch which chain-drives the rear axle. It is geared down by a big sprocket and three separate shafts so there is almost no limit to its power. My grand kids wore out two sets of rear tires by tieing the tractor to a tree, etc., and then putting it in gear. Because of all the power, the original 1/2-in. dia. shaft on the rear axle bent, so I replaced it with a bigger 5/8-in. dia. one. The pedal tractor originally drove off only the right rear wheel. I welded up the rear axle so that both rear wheels turn together.
"The tractor still has its original front and rear wheels, seat, and steering wheel. I added a throttle lever which I use to control tractor speed.
"The tractor has appeared in many parades over the years. I built several different implements to the same scale including a hay rack, chisel plow, anhydrous trailer, grain drill and a 4-bottom plow moldboard plow. The implements are mostly for show û I don't use them on my farm."
Contact: FARM SHOW Followup, Frank L. Miller Farms, 307 Iowa Ave., Mott, N.Dak. 58646 (ph 701 824-2637).
To read the rest of this story, download this issue below or click
here to register with your account number.
