You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Homemade 3-Pt. Bale Fork
I used part of an old 2-ton truck frame, the rear axle off a car, and scrap steel to build a low-cost, 3-pt. bale fork.
The bale fork is equipped with a 30-in. long spear on top and a pair of 4 1/2-ft. long steel arms at the bottom that slide under the bale. They're mounted on a 3-ft. long section of truck fram
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Homemade 3-Pt. Bale Fork BALE HANDLING Bale Handling (31B) 23-6-35 I used part of an old 2-ton truck frame, the rear axle off a car, and scrap steel to build a low-cost, 3-pt. bale fork.
The bale fork is equipped with a 30-in. long spear on top and a pair of 4 1/2-ft. long steel arms at the bottom that slide under the bale. They're mounted on a 3-ft. long section of truck frame that has 3-pt. brackets welded onto it. To make the spear, I cut off part of the car rear axle and sharpened one end to a point. I bolted the wheel hub at the other end to some steel that I welded in between the two members of the truck frame and used 2 1/2-in. sq. tubing to make the two arms and welded them to the truck frame. I also shaped the ends of both arms into points.
I welded a steel pin onto each side of the truck frame to make the lower lift arms and welded a steel bracket onto the truck frame to make the upper link arm. (George Ribble, 25766 Mt. Ragen Rd., Hettick, Ill. 626490
To read the rest of this story, download this issue below or click
here to register with your account number.
