You have reached your limit of 5 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Hydraulic-Powered Bale Unroller Fits Any Tractor
For years, we've seen farmers mount wheels on front of tractors to roll round bales out on the ground. Now, a pair of Florida farmers have taken the idea one step further by powering the up-front wheel with a hydraulic motor.
Carlton Oswald and his neighbor Bill Conrad say their new unroller is much more aggressi
..........
You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Hydraulic-Powered Bale Unroller Fits Any Tractor BALE HANDLING Bale Handling (31B) 22-2-2 For years, we've seen farmers mount wheels on front of tractors to roll round bales out on the ground. Now, a pair of Florida farmers have taken the idea one step further by powering the up-front wheel with a hydraulic motor.
Carlton Oswald and his neighbor Bill Conrad say their new unroller is much more aggressive than a free-wheeling wheel.
"It rolls out hay like a red carpet," says Oswald. "About 40 or 50 cows will consume 1 roll in a day and leave the area as clean as a whistle. I figure I save 1/3 more hay by feeding this way, compared with bale feeders." The men used a 15-in. implement wheel but say almost any size wheel will work so long as it runs 12 to 18 in. off the ground. A frame built out of 6 in. channel iron bolts to the weight bracket on front of the tractor and the unit can be easily removed when not needed.
The wheel is chain-driven counterclockwise by a 353 rpm 15 gpm hydraulic motor. "We use #50 roller chain with a 15-tooth sprocket on the motor and a 30-tooth sprocket on the wheel hub," Oswald says. "The wheel mounts with two flange-type bearings, one on either side of the wheel. The hub for the wheel welds on the axle and the axle mounts on two 6-in. pieces of channel iron that ex-tend 22 in. in front of the tractor."
The men have built two units, one for a Case-IH 5130 and the other for a Deere 5400. They use them to unroll 300 to 400 5 by 5-ft. round bales weighing 1,000 to 1,200 lbs. a year.
Out-of-pocket expense was about $200 apiece, including a new hydraulic motor. For more information, contact: FARM SHOW Followup, Carlton Oswald, 5720 Grove Rd., Bascom, Fla. 32423 (ph 850 569-2887).
To read the rest of this story, download this issue below or click
here to register with your account number.
